TL Audio 5060 - Manual (Page 20)

16
5.3
Frequently Asked Questions (FAQs).
Q:
5060 is a stereo unit yet there is only one set of controls, why is this?
A: The 5060’s single set of controls affect both channels simultaneously, since the unit always works in linked stereo
mode. To operate in mono mode, simply run your mono signal through the left channel input/output (either the
line input, or the instrument input if applicable).
Q:
The Threshold, Ratio, Attack, Release and Knee controls aren’t working.
A: This is because the Program control is not set to Manual mode, and these parameters are all fixed within the
5060.
Q:
Why is it I occasionally get some LF distortion on certain settings?
A: This happens when a Fast Release time is selected on certain bass-heavy sources. The compressor is then forced in
and out of gain reduction within an individual cycle, and thus distortion is caused on the lower frequencies.
Selecting a slow attack/release time will cure the problem.
Q:
Can I use the preset settings on instruments other than those recommended?
A: Absolutely. If it sounds good, use it!
Q:
The Gain Make-Up control isn’t working.
A: This control is only active when the ‘Compressor On’ switch is engaged.
Q:
The 5060 is a stereo unit but there is only one valve in it. Why?
A: The unit employs a single ECC83/12AX7A dual triode valve, so called because it features two separate valve stages
within one glass housing. Each channel of the 5060 employs one of these stages.
Q:
How long do the valves last before they need replacing?
A: This very much depends on the valve itself, whether the unit is left switched on all the time and how much the
unit is moved around. On average we’d say about four years. The valve itself is easily sourced and relatively
inexpensive - contact your dealer for details.
6. SERVICE
Should the 5060 require service, it must be taken or posted to an authorised dealer with a description of the fault. Please
retain the original packing for possible future use, and ensure the unit is suitably protected during transit. The manufacturer
cannot accept responsibility for damage caused during transportation.
The 5060 is supported by a limited warranty for a period of one year from the date of purchase. During this period, any
faults due to defective materials or workmanship will be repaired free of charge. The warranty excludes damage caused by
deliberate or accidental misuse, tampering, operation on the incorrect mains voltage, or without the correct type and value of
fuse fitted. It is the user’s responsibility to ensure fitness for purpose in any particular application. The warranty is limited to
the original purchase price of the equipment, and excludes any consequential damage or loss. When claiming service under
warranty, proof of purchase date must be included with the equipment for repair.
Please record the following details, and retain proof of purchase: