Mounting the antenna on the receiver's front panel, E p. 19, "mounting the, Antenna on the receiver's front panel – Toa S-D7802 User Manual
Page 19
19
9.4. mounting the Antenna on the Receiver's Front Panel
It is possible to install the supplied antennas on the receiver's front panel using the supplied front mount cord
with BNC plug (65 cm).
Detach the plug cap on the rack mounting bracket, run the cable's BNC jack through the mounting hole, then
secure the BNC jack with the supplied washer and nut.
Connect the cable's BNC plug to the receiver's rear-mounted Antenna input connector.
Connect the antenna's BNC plug to the BNC jack secured to the mount bracket.
[Antenna front view]
[BNC cable assembly drawing]
The figure shows the installation method for the antenna B.
Follow the same method for installing the antenna A.
Antenna (Accessory)
Nut (Accessory)
Washer (Accessory)
Front mount cord with BNC plug (65 cm) (Accessory)