Toa WA-1822C - Manual (Page 11)

11
9. USING THE CASSETTE DECK (WA-1822C only)
9.1. Nomenclature and Functions
2 3 3 4 4 5 6
1
7
8
9
10
11
12
1. Cassette door
Insert the tape into the door's receptacle.
Notes
• When the power is switched ON, cassette deck
motor noise may be heard for approximately 1
second during initial setting.
• Do not subject the unit to impacts and shocks
during cassette deck operation to avoid
malfunctions.
• When operating on batteries, the cassette deck
may not function properly if the batteries begin to
lose their charge.
2. Recording button [ ] / Recording indicator
lamp (red)
Pressing this button places the deck in recording
standby mode, causing the Pause indicator lamp
to light orange, the Recording indicator lamp to
light red, and the Direction indicator lamp
(indicating which direction the tape will record) to
flash green. In this state, recording is started by
pressing either the flashing Play button (Direction
indicator lamp) indicating the tape direction or the
Pause button.
3. Fast forward/rewind buttons [ ]
Wind the tape in the forward or reverse direction
at top speed.
4. Play button [ ] / Direction indicator lamp
(green)
Plays the tape in the arrow-indicated direction.
5. Stop button [ ]
Stops tape operation.
6. Pause button [ ] /Pause indicator lamp
(orange)
Temporarily stops tape operation. Note that this
button cannot be used during fast forward or
rewind operation.
7. EJECT [ ]
Opens the cassette door to allow the tape to be
loaded or removed.
Note: Avoid pressing the EJECT [
] during tape
operation. When removing the tape, press
the Stop button [
] to be sure that the
tape is stopped, then press the EJECT [ ].
8. Tape counter
Indicates the amount of tape used. The counter
reading increases as the tape moves forward,
and decreases as it moves backward.
Note: The counter is reset to [0000] when the
power switch is switched off or the
cassette door is opened.
9. Reset button
Resets the counter to [0000].
10. Tape volume control
Adjusts the tape sound volume.
11. Tape speed control
Adjusts the tape speed. Tape operation is set to
normal speed when the knob marker points up.
Tape speed increases as the control is rotated
clockwise, and decreases when rotated
counterclockwise. This control can be only used
in playback mode.
Note: Irrespective of the tape speed setting, the
tape moves at normal speed after
automatically reversed.
12. Operating mode selector switch
Selects one of 3 tape operating modes: ,
, or .
/
/