Toa C-CH100FH - Manual (Page 9)

8.2. When Using the Outdoor Pan/Tilt Drive C-PH200
Modify the housing cable supplied with the pan/tilt drive as follows. Push the cable into the inside through the
cord entry bushing
located in the bottom panel of the base , then make connection as shown in the figure
below or in the figure on page 10.
Wire No. Purpose of use Wire color Connection method
1 Green
2 Yellow
3 Blue
4 Gray
5 Red
6 Black
7 Purple
Orange
White
Peach
Brown
8
9
10
11
12
13
AC power (common)
Not used.
Not used.
Not used.
Connects to the camera's video output terminal.
AC power
Camera power Connects to the terminal block on the 24 VAC camera.
Defroster
Wiper
Auxiliary
Lens (common) Connects to the 4-pin connector on the zoom lens.
Connects to the 4-pin connector on the zoom lens.
Iris
Focus
Zoom
Auxiliary
Video output
Coaxial cable shielded mesh
Coaxial cable conductor
Connects to the 24 VAC terminal (refer to the figure
on page 8) of the power input terminal block.
Memo: Cable numbers are indicated on the cable.
8.2.1. Modifying the housing cable
Remove the solderless terminal and mount the 4-pin connector supplied with the zoom lens. When a wire
does not snugly fit into the connector terminal hole, extend the wire that mates with the terminal hole. Connect
wire No. 7 to pin No. 1, wire No. 9 to pin No. 3, and wire No. 10 to pin No. 4.
Insulate unused solderless terminals with heat-contracted tube or tape.
8.2.2. Connection when using the housing in combination with the single-cable camera
Power input terminal block
inside the housing
When using the C-CH100, wires and
do not need to be connected.
Housing cable
Connector (supplied with the zoom lens)
Zoom lens
Single-cable camera