Toa VX-200PS ER - Manual (Page 6)

6
2.2. VX-200PS Power Supply Unit
1
[Rear]
2
3
4
1. Power indicator [POWER]
These indicators (one for each channel) light
green when DC power is output.
2. DC output terminal 1, 2 [PS OUT]
Connects to the PS IN terminals of the VX-
2000DS Emergency Power Supply.
3. AC fuse 1, 2
Type: 250 V, T3.15 A L
4. AC inlet
Using the supplied power cord, connect this
AC line receptacle to a power source of 230 V
AC, 50/60 Hz.
Note
The VX-200PS Power Supply unit is designed for exclusive use with the VX-2000 system, SX-2000 system,
and VM-3000 system.
Up to 3 VX-200PS Power Supply units can be mounted in the V-2000PF Power Supply Frame. The VX-
200PS unit has 2 DC output channels, and up to 3 units (6 ch) can be connected to one VX-2000DS
Emergency Power Supply. Use the VX-200PS in the number suited to the required total system power.
2.3. VX-2000PF Power Supply Frame
[VX-2000PF Components]
This unit is comprised of the following components. For the component assembly, refer to p. 7.
1. Front panel .................... 1
2. Side panel ..................... 2
The VX-2000PF permits the VX-200PS Power Supply to be mounted in an equipment rack.
Up to 3 VX-200PS units can be installed in the VX-2000PF. Refer to p. 8 for the VX-200PS mounting
procedure.
3. Chassis (VX-200PS guide rails pre-mounted) ..............1
4. Fixing bracket* ..............................................................1
[Front]
[Top]
2 2
3 1 4
* The Fixing bracket is not supplied
with the previous VX-2000PF.
(Refer to p. 9.)