Crestron electronic Surround Sound Tuning Kit - Manual (Page 5)

Crestron Professional Surround Sound Tuning Kit
Professional Surround Sound
Tuning Kit: Quickstart
Introduction
The following steps are designed to guide you through the basic hookup and use of
your Professional Surround Sound Tuning Kit.
Follow this checklist to tune your system.
1. Hardware Hookup
All components in the system should be powered off while making
connections.
NOTE: Crestron’s Professional Surround Sound Tuning Kit may be used with an
AMS, an AMS-AIP or a PSPHD. For simplicity within this guide, all three models
will hereinafter collectively be referred to as “the processor”.
Remove the plastic cover from the front of the processor.
Place the microphone stand upright.
Attach the microphone holder to the stand.
Insert the microphone in a vertical position in the holder.
NOTE: You must place the microphone in a vertical position with the capsule
facing the ceiling for all measurements.
Connect the mini female XLR end of the female mini XLR to male XLR
cable to the microphone.
NOTE: Use care when attaching the mini XLR cable so as not to strain the
connector.
For the AMS, connect the male XLR end of the cable to the XLR end of the
female XLR to stereo 3.5 mm cable. For the PSPHD, connect the male XLR
end of the cable to the XLR end of the female XLR to mini XLR cable.
Operations Guide – DOC. 6565C Quickstart • iii