Crestron electronic Surround Sound Tuning Kit - Manual (Page 6)

Professional Surround Sound Tuning Kit Crestron
For the AMS, connect the stereo 3.5 mm plug to the microphone input on
the AMS. For the PSPHD, connect the mini XLR plug to the microphone
input on the PSPHD.
NOTE: Use care when attaching the microphone cable so as not to strain the
connector.
Using the included USB cable, connect your PC to the USB port on the
front of the processor.
2. Room EQ Setup
NOTE: When Pro Sound Tools™ or PROCISE™ Tools is run for the first time, a
setup wizard will take your through the process. Thereafter, the Configure button
can be used to initiate the process.
Insert the CD that came with the kit and click Add/Change Mic Setup File.
Select the file for the microphone that came with your kit.
When a center speaker or subwoofer is not used, un-check the Front Center
Speaker and/or Subwoofer checkboxes.
Any subwoofer low-pass filter should be defeated or set to its maximum
frequency. Any subwoofer gain settings should be set to their nominal or 12
o’clock position. Also, any sort of auto standby or sleep mode for the
subwoofer should be disabled.
Click Room Equalization Setup… to begin the process. The “Job
Information” screen is used to record the name of the customer or job and
the name of the technician performing the job.
Click the forward arrow to proceed to the “Options” screen. The” Options”
screen is where you select the microphone file to match the microphone you
are using.
Select your microphone and click the forward arrow to proceed to the
“Measurement” screen.
3. Measurement
Quiet the room as much as possible.
Turn off phones, TVs, radios, air conditioners, etc. and close any open
windows.
Refrain from talking and do not sit or stand directly between any of the
speakers and the microphone.
NOTE: Do not touch the microphone stand or cable during the measurement
process.
A. Position 1 Measurement
Place the microphone at the primary listening location, at the ear height of a
listener seated at this location.
iv • Quickstart Operations Guide – DOC. 6565C