Triner Scale TS60KD-1010 - Manual (Page 2)

Assembly Guide Triner TS60KD-1010 Platform Scale
2
Note: The location where the scale will be installed is very important. The scale MUST be
installed on a firm and level concrete pad. Never install the scale on asphalt. Asphalt is not
hard enough to take heavy loads and the scale will sink into the asphalt over time.
Installation Procedure
1. Unpack and inspect the system components.
Below is a list of the parts and quantity:
a. Scale Platforms (2)
b. Scale Ramps (4)
c. Leveling Feet (8)
d. Foot Retaining Plates (8)
e. Indicator Stand (1)
f. Digital Indicator (1)
g. ½” Concrete Anchor Bolts (44)
2. Install the leveling feet into the weighing deck’s load cells.
Using a forklift, lift each deck and thread the feet into the load cells located
at the corners of the decks.
FIGURE 1: Underside view of foot threaded into load cell.