Twin Eagles TESB132-B - Manual (Page 7)

6
OPERATING INSTRUCTIONS
1. Make sure all knobs are in the “OFF” position.
2. Turn “on” the gas at source. Caution: If you smell gas, shut off gas supply and call for service.
3. Before lighting, remove the side burner cover or any cooking utensils from the burner grate.
4. Push-in and turn the burner knob counterclockwise to “HI” (LARGE FLAME) position, and hold
the knob in. You should hear a continuous clicking sound and see sparks being provided to the
burner. (If clicking sound is weak, replace the 9V battery. See page 1).
5. If the burner does not ignite within 5 seconds, turn the burner to “OFF” and wait for five minutes.
Repeat the above procedures or try the following manual lighting procedures
a. Hold a lit match next to the burner ports
b. Push and turn the burner knob counterclockwise to ignite the burner.
6. Adjust flame setting to “LOW” or “MEDIUM” or “HIGH”, if desired.
7. Caution: Do not leave the side burner unattended while cooking.
8. To shutdown the burner, push and turn the burner knob clockwise to “OFF”.
9. For complete shutdown, turn “off” the gas at source.
CLEANING & MAINTENANCE
STAINLESS STEEL
The Twin Eagles Side Burner is made of all welded stainless steel. It is non-rusting and non-
magnetic. Never clean the stainless steel when it is hot. After the initial use, certain areas of the side
burner may discolor. This is a normal discoloration caused by the intense heat given off by the burners.
Specks of grease can gather on the surface of the stainless steel and get baked-on. These can be
removed by using a mild abrasive pad (like Scotch Brite) with a stainless steel cleaner. Use the mildest
cleaner and always scrub in the direction of the grain.
Do not use steel wool to clean the side burner. Do not use abrasives on the polished highlights.
Be extra careful when cleaning around the highlights. Metal polisher or mild chrome cleaner can be used
to bring back the luster on highlights. To touch-up minor scratches in the stainless steel, sand the
affected surface very lightly, with 100-dry grit emery sandpaper in the direction of the grain.