Twin Eagles TETG30-B - Manual (Page 6)

GETTING STARTED – T WIN E AGLES T EPPANYAKI G RIDDLE
Safe and satisfactory operation of the Teppanyaki Griddle depends upon its proper installation. The installation,
adjustments and service of the Griddle must be performed only by a qualified installer and service technician.
Proper location and proper use is essential to insure safe and continued trouble-free operation. Any alterations
made to the appliance will void the product’s warranty.
Before installing, check the rating/serial plate of the Teppanyaki Griddle. Use only the electrical power supply and
type of gas supply (natural or propane) as specified on the rating/serial plate. This information is found on the
serial plate, located on the inside wall of the left hand side panel .
Electrical Specification
The appliance should only be taken apart by a qualified technician, or electrical shock may occur. It is rated
at120V, 60Hz, 900W and 8A.
Propane or LP: If your griddle is factory built for L.P., the regulator supplied is set for 11” water column
and is for use with L.P. gas only. The factory-supplied regulator and hose must be used with a 20 lb. L.P.
cylinder. Do not use any replacement regulator other than that specified by Twin Eagles
Natural Gas or NG: If the griddle is factory built for natural gas, the regulator supplied is set for 4” water
column. Do not use any replacement regulator other than that specified by Twin Eagles
SHIPMENT: This Teppanyaki griddle was inspected before leaving the factory. The shipping carrier assumes full
responsibility for safe delivery of the appliance. Check for possible shipping damage immediately after unpacking.
If the griddle is found to be damaged, save the packaging material and contact the shipping carrier immediately.
UNPACKING: Remove all packaging materials, labels and protective plastic film. DO NOT LEAVE UNIT
UNDER THE SUN WITH PROTECTIVE PLASTIC FILM ON FOR A LONG PERIOD OF TIME AS IT WILL
BECOME DIFFICULT TO REMOVE THE FILM.
1