TYREDOG TD-1000A-X Owners Manual - Manual (Page 16)

15
Visually inspect your tyre’s valves for any damage or defect before fitting to
ensure further damage does not occur. If you do notice that something is
not right with your valves, have them checked by a tyre professional.
1. After removing the original valve caps, slide the SecureFit fixing ring over
the valve stem with the flat surface towards the wheel.
2. Screw the Tyredog sensor on in a clockwise direction until you feel the
valve stem come under pressure.
3. Slide the SecureFit fixing ring back up to the base of the sensor and line
up the grooves. Once locked into place, tighten the hex screw with the
supplied Allen key.
If you do not wish to use the SecureFit fixing ring, only follow step 2.