TYREDOG TD-1000A-X Owners Manual - Manual (Page 21)

20
+
System Reset
To reset all stored values, turn on the monitor while holding the Temperature
button. Once the power is turned on, continue holding the Temperature button
and the monitor will beep once then again 1 second later to confirm that the
settings have been cleared. You must continue holding the Temperature
button until the second beep is heard or settings will not be cleared.
+
Replacement Sensor Learn Mode
If in any case a sensor is lost, stolen or damaged, it can be replaced with a
‘Learnable Sensor.’ These sensors have their own special code and can only
replace those of the same type and wheel location. For example, if sensor FR is
damaged, it can only be replaced by a ‘FR Learnable sensor.’ Learnable
sensors can be purchased individually at an authorized Tyredog reseller.
To enter learn mode, turn on the monitor while holding the Mute button. Once
the power is turned on, the monitor will beep, and then show ‘LEN’ in the four
corners of the screen. You must continue holding the Mute button until ‘LEN’ is
displayed or Learn Mode will not be initiated.