USL JSD-80 Manual - Manual (Page 3)

USL, Inc. JSD-80 Instruction Manual Page 3 3rd Edition. February, 2006
Please read the entire manual before begin-
ning your installation.
1.1 Safety Notices
General Safety Summary European
Review the following safety precautions
to avoid injury and prevent damage to
this product. To avoid potential risk, use
this product only as specifi ed and only for
the purpose described in the instruction
manual.
To Avoid Fire and Personal Injury:
• Use Correct Power Cable. Use only
the power cable provided. Ensure
that the AC power outlet is located
near the product and is easily acces-
sible.
• Use a Correctly Grounded Power
Source. The Power Supply earth
ground is established through the
ground conductor in the power cable.
To avoid the potential of electric
shock, the ground conductor must be
correct.
• Observe Source Ratings. To avoid risk
of fi re or electric shock, the power
source must be 100 - 240 V AC 50-60
Hz. (European Models)
• Do Not Operate with Suspected Fail-
ures. If you suspect there is damage
or malfunction with this product, call
the factory.
• Do Not Attempt Repair. Only a trained
factory service person is authorized
to repair this product.
• Do Not Operate this Product Near
Heat Sources. This product should
not be located near heat sources such
as radiators, heat registers, or stoves.
• Provide Proper Ventilation. The oper-
ating temperature range is between
0° C and 40° C. The humidity range is
between 20% and 80%, non-condens-
ing. The cooling method is by convec-
tion.
• Keep Product Surfaces Clean and Dry.
Disconnect the power cable from the
power source before cleaning. Do not
use liquid cleaners or aerosol clean-
ers. Use a damp cloth for cleaning.
• Do Not Push Objects Into Opening
of this Product. Never insert objects
into the product through openings.
• Do Not Operate In Wet or Damp Con-
ditions.
• Do Not Operate in an Explosive Atmo-
sphere.
• Prevent the Spilling of Liquids onto
the System Components.
• Inspect the Power Cable and all
Cables prior to Use. Confi rm that the
power cable and other interconnect-
ing cables are free from damage.
Safety Standard
The EN 60950 standard specifies safety
design requirements that reduce or elimi-
nate the risk of personal injury to both the
product user and service personnel. This
product is designed and tested to meet the
standards of the International Electrotech-
nical Commission (IEC) European Norm EN
60950, IEC 60950 (The Standard for Infor-
mation Technology Equipment Including
Electrical Business Equipment).
Section 1. Introduction