Ram Trucks 2015 ProMaster - User Guide - Manual (Page 100)

Wheel Covers
CAUTION!
Use a back-and-forth motion to remove the hub cap. Do not use a twisting motion
when removing the hub cap, damage to the hub cap finish may occur.
The wheel covers on the vehicle are held in place by the wheel lug bolts and can be
removed after the wheel lug bolts are taken off.
JUMP-STARTING
Preparations For Jump-Starting
NOTE:
Only use the recommended jump starting
location.
The vehicle’s jump starting locations are
located under the hood in the engine
compartment on the driver’s side.
• The Remote Positive
(+) Post is cov-
ered with a protective cap located on
the side of the Front Power Distribu-
tion Center.
• The Remote Negative (-) Post is lo-
cated on the core support closest to
the front of the vehicle.
Jump-Starting Procedure
If frequent jump-starting is required to start your vehicle you should have the battery
and charging system inspected at your authorized dealer.
Connecting The Jumper Cables
1. Connect the positive
(+) end of the jumper cable to the remote positive (+) post
of the discharged vehicle.
2. Connect the opposite end of the positive (+) jumper cable to the positive (+) post
of the booster battery.
Remote Battery Posts
1 — Remote Positive (+) Jump Starting
Post
2 — Remote Negative (-) Jump Starting
Post
W H A T T O D O I N E M E R G E N C I E S
98