Cobra Electronics XRS 9740 - Manual (Page 5)

To Turn On the Unit and Adjust the Audio Volume
Rotate the On-Off/
Volume control
clockwise (away
from you). Tone Visual Display Voice
Three beeps Testing
System Ready
The display will then
cycle through the
user mode settings
(city or highway,
Intellimute and
SmartPower status).
Testing, then three
beeps
System Ready
Voice Alert
Start-up is complete when the display continuously shows the
current compass direction (N, NE, E, SE, S, SW, W or NW) plus
single letters indicating current user mode settings (c = City
mode, City X Beep Off mode and City X+K mode, h = Highway
mode, i = IntelliMute on).
Getting Started
Getting Started
•
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Your Detector
Nothing Comes Close to a Cobra ® 5
Installation
Intro Operation Customer
Assistance Warranty
Notice
Secondary Icons
Your Detector
4 English
Dashboard Mounting
System Ready
Voice Alert
Power On
Testing
On-Off/
Volume Control
Rotate clockwise
(away from you)
NOTE
In some vehicles, power is supplied to the cigarette
lighter even while the ignition is off. If this is the case
with your vehicle and you have turned the SmartPower
off, you should turn off or unplug your detector when
parking for lengthy periods. Cobra recommends leaving
SmartPower at the factory setting, which is on.
Intro Operation Customer
Assistance Warranty
Notice
Main Icons
Secondary Icons
Start-Up Complete
NW h
1. Place the detector on the dashboard to find a location
where the unit has a clear, level view of the road.
The angle can NOT be adjusted after mounting.
2. Remove the paper backing
from one side of the hook-
and-loop fastener.
3. Attach the pad to the
dashboard at your chosen
location and remove the
other paper backing.
4. Attach the detector to the
hook-and-loop fastener.
You can remove and
reattach the unit as
often as you like.
5. Plug the power cord
into the detector.
6. Plug the cigarette lighter
adapter on the power
cord into your vehicle’s
cigarette lighter.