CyberResearch PCIDIO 48H - Manual (Page 16)

8
• Installation
2.2 Unpacking
Your card contains sensitive electronic components that can be easily
damaged by static electricity.
The card should be put on a grounded anti -static mat. The operator should
wear an anti -static wristband, grounded at the same point as the anti -static
mat.
Inspect the card module carton for obvious damage. Shipping and
handling may cause damage to your module. Be sure there is no shipping
and handling damage on the module before processing.
After opening the card module carton, extract the system module and place
it only on a grounded anti
-static surface with components side up.
Again inspect the module for damages. Press down on all the socketed
IC's to make sure that they are properly seated. Do this only with the
module place on a firm flat surface.
Note: DO NOT APPLY POWER TO THE CARD IF IT HAS BEEN DAMAGED.
You are now ready to install your 24H/48H/96H series product.