Carrier 51CV/GY - Manual (Page 12)

I
Remove screw inserted through center hole of
upper guide in Step 19. This allows for freedom of
movement in future steps. DO NOT RAISE SASH.*4
I
Insert casing (without chassis) into framework
now secured in window. Push casing outward, until
bottom slides up and over bend in lower track and
casing’s top channel rests against upper guide of
wing panel assembly.
i Expand accordion folds to meet sides of
installed casing. Screw accordion side panels to
casing sides through pre-made screw openings
in panels. Be sure to use all 3 screw openings to
prevent air seepage.
I With one person on each side, lift chassis
and slide into casing in window. Slide in chassis all
the way.
Make pencil mark through center hole in bot­
tom of casing. Drill hole into window sill at spot.
Screw casing to window sill.
I With chassis back in casing, slide security
screw to locked position and tighten. Refer to
Step 6.*2
I Align center hole in top channel of casing with
center hole in upper guide and previously drilled
hole in sash. Replace and fasten screw removed in
Step 22. TIGHTEN SECURELY.
Cut foam window seal from unit accessory
mounting kit to fit window width. Insert foam down
between top of raised lower sash and glass panes of
upper sash making sure of a firm fit to provide an air
seal. This also prevents insects from gaining
entrance.
*4 When casing is installed in window, using proper installa­
tion steps, unit is property pitched towards the outdoors to
allow for condensation run-off. An Accessory External Drain
Kit is available to route excess unit condensation away from
building exterior. Contact your independent Carrier Dealer, or
call 1-800-CARRIER to order kit.
\
Replace grille frame on front of unit and fasten
securing screws removed in Step 5.
Replace grille insert removed in Step 4.
Plug in unit, slide excess cord into cord storage
opening.*5
'5 Unit is designed with power cord extending from right side
of control panel. If wall sodret is located on leftside, unitcan
be modified for power cord to exit on leftside of unit. Remove
grille (Step 4). Remove grille frame (Step 5). Gently slide off
control panel knobs. Remove screws holding control panel in
place and remove panel. Route power cord over to leftside ,(
along front-bottom edge of unit Use pliers to snap outpre-
scored plastic exitsection In lower l e f t corner of grille frame.
Replace control panel and screws, control knobs, grille frame
and screws, and grille. Make sure power cord fits snugly and
properly exits l e f t corner of frame.