Automatic system rearming, Full time system diagnostics – Clarion Ungo MS2004 User Manual

Page 12

Advertising
background image

Page 8 - MS2004 Owner’s Manual

6. Enter the code again and hold for 10 seconds on the last press.

• The siren will chirp 3 times.

• The parking lights will flash 3 times.

• The LED will flash a number of times equal to the new code.

7.

Release the switch.

8.

Turn off the ignition.

Automatic System Rearming

This feature, which can be turned on by your installer during the installation, insures the security
of the system by protecting your car in case of an accidental disarm.

If your system becomes disarmed due to an accidental press of the Arm/Disarm Button, the
system will automatically rearm if no other activity is detected within one minute.

One minute after Remote Disarming, the system will alert you with a series of chirps, then arm.
(If the Passive Door Locking feature is selected during the installation, the system will also relock
the doors.)

Any of the following will cancel Automatic System Rearming:

• Turn on the ignition.
• Open the Trunk or Hood.
• Activate Auxiliary Function 1 or 2.

Automatic System Rearming is independent of Passive Arming and only takes place if the system
was Armed (actively or passively) for at least 10 seconds and then Disarmed by the Remote
Transmitter.

Full Time System Diagnostics

The system continuously monitors all protected zones, even when it is not armed, and warns you
if it detects a problem when you turn off the ignition.

1. Turn off the ignition.
2. If the siren chirps twice, the system has detected a problem.*
3. The status LED will flash to indicate the zone where the problem has been detected.

1 flash

=

door

3 flashes

=

hood / trunk

4 flashes

=

optional sensor

* The system must see the zone open or active for at least 20 seconds before the zone is determined to be defective.

This way, opening the car door before turning off the ignition will not cause the siren to emit the warning chirps.

Advertising