Clarion Ungo MS2004 - Manual (Page 14)

Dome Light Control
For increased safety and convenience this optional feature will automatically turn on the dome
light when you Disarm the system.
With this feature installed, the dome light will turn on for 30 seconds when the system is disarmed
(or unlocked in Valet Mode) using the Remote Transmitter.
Auxiliary Function Outputs
The system is equipped with two Auxiliary Function outputs that can be used to control a variety
of additional features including, electric trunk release, remote car starter, power windows, power
sunroof, auxiliary lighting, stereo system valet, etc.
Auxiliary Function 1 - momentary
Normally, this function is used to activate a power trunk release.
To operate Aux. 1, press Button 3 for three seconds.
This function will stay active for as long as Button 3 is held.
Auxiliary Function 2 - momentary / latched / timed (resets with arm and disarm)
This Auxiliary Function has three selectable operating modes which can be programmed by your
installer to allow custom operation of your vehicle and its accessories.
Momentary - the system will provide an output for as long as the Transmitter button is held.
Latched - the system will provide an output that turns on when the transmitter button is pressed and turns off when the
transmitter button is pressed again.
Insider Tip: The Latched mode works great for activating auxiliary lighting such as neon or off road lights. It can also be
used to activate your stereo system so that it be turned on without having the key in the ignition. In either case the auxiliary
function will turn off when the system is armed or disarmed so that you do not forget to turn it off and drain your vehicle’s
battery.
Timed - the system will provide an output that turns on for 30 seconds each time the transmitter button is pressed. If the
button is pressed again during the 30 seconds, the output will turn off.
Insider Tip: The Timed mode is especially useful to turn on the vehicle’s head lights to light the path to your door at night.
To operate Aux. 2, press Button 4.
When the Latched or Timed outputs are activated:
• Arming the system will turn off the Aux. 2 output if it was turned on while the system was
disarmed.
• Disarming the system will turn off the Aux. 2 output if it was turned on while the system
was armed.
Trunk Disarm*
If Auxiliary Function 1 is being used to remotely open your car’s trunk, your installer can program
the system to allow you to automatically disarm the alarm when auxiliary function 1 is pressed
while the system is armed. This will allow you to load or retrieve packages from the trunk without
having to first disarm the alarm.
Page 10 - MS2004 Owner’s Manual