Clarion Ungo MS2004 - Manual (Page 9)

MS2004 Owner’s Manual - Page 5
To Bypass the sensors:
1. After arming the system, press Button 1 again on the Remote Transmitter within 5
seconds.
• The siren will chirp 5 times, indicating the sensors have been bypassed.
2. The sensors will remain bypassed until the next time the system is armed.
Remote Disarming
To Disarm the System:
Press Button 2.
• The siren/horn will chirp twice.*
• The doors will unlock.
• The parking lights will flash twice.**
• The LED will turn off.
* The siren chirps and light flashes during disarming will alert you if the system had been triggered while
armed.
2 chirps / 2 flashes = normal disarming
3 chirps / 3 flashes = Tamper Alert - system was triggered
** If the Passenger Unlock Feature is installed, pressing Button 2 will unlock only the driver’s door. Pressing the
unlock Button 2 again unlocks all doors.
Tamper Alert
On Disarming, if the system responds with three chirps, indicating the system was triggered, the
LED will flash for 60 seconds to indicate the zone that triggered the system.
LED Flashes (60 seconds):
1 flash = door
2 flashes = shock sensor
3 flashes = trunk
4 flashes = optional sensor
example: flash-flash-pause-flash-flash-pause = shock sensor
Note: Turning on the ignition will cancel Tamper Alert zone indications.
Silent Arming / Disarming
Each Remote Transmitter can be individually set to always Arm and Disarm the system with or
without chirp confirmation at the time they are programmed into the system (see Adding a New
Transmitter into the System).
To temporarily cancel the Arming and Disarming confirmation chirps, you can Arm or Disarm the
system by pressing Button 3.
Note: The confirmation chirps will only be cancelled if the system status is normal. The chirp indications for Tamper
Alert and the open zone warning will not be cancelled when the system is Armed or Disarmed silently .