Care or your cooler – Sears KENMORE 661.62442 User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CARE or YOUR COOLER
PUTTING ON NiEW PAD (Pig. 21)
SEARS REPLACEMENT PADS
THE PADS NEED NO PREWETTING
C£
Put the lower roller in pad
0
Fit the lower roller into the botton slots in the
frame
0
Push the top roller through the pad Fit the roll
end over the pad motor shaft drive block
0 Push the top roller end into the bearing.
® Turn the bearing arm to hold the roller
(6)
TUCK
THE
PAD
EDGES
UNDER
THE
2
GUIDES ON EACH SIDE.
0
Put the two small center rollers in place. Snap
the ends into the holders, (See lubrication
instructions below)
OILING (Fig.22)
Use SAE 20 Non-detergent motor oil once
per year.
1
Fill the two blower shaft bearing cups @
2
Put two or three drops in the two oii f)!l tubes on the
biower motor (§) (Motors without oi! fiit tubes
have lifetime lubrication)
3
Pul two or three drops in the end bearing on each pad
motor (g)
BLOWER BELT ADJUSTMENT (Fig. 23)
CAUTION:
DO
NOT
ADJUST
BELTTENSION
BY
CHANGING
THE
DIAMETER
OF
THE
MOTOR
PULLEY.
ADJUST
BELT
TENSION
ONLY BY MOVING THE MOTOR BRACKET.
1 If you can easily move the belt over 1 inch, it
needs ad|ustment,
2
To adjust belt tension, loosen the three motor
mount bolts
3
Push the motor to tighten the belt until belt
moves about % inch with finger force.
4 Tighten the three motor mount bolts
MODELNUMBERSEARS PAD NUMBER
661.623920
42-6293
661.624420
42-6293
661.624530
42-6294
661.624630
42-6295
m.6g4670_________
42-6295
13