Sears KENMORE 661.62442 - Manual (Page 8)

IMST ä LLÄTION
FINAL ASSEMBLY AND ADJUSTMENT
PUT FLOAT VALVE IN COOLER
Put the float valve through the spout hole and
cabinet hole Tighten the ring nut. Be sure the float
moves straight up and down
TURN THE FLOAT
UNTIL A NARROW SIDE IS UP. Snap the Splash
Guard Covet into the Water Spout as shown The
Water Spout and Splash Guard Cover are provided
to prevent water from "spurting" and splashing out­
side the Water Reservoir,
CONNECT WATER LINE
For outdoor Hook Up, use #62527 Copper Hook Up
Kit or #62528 Plastic Hook Up Kit, Both kits contain
ali necessary fittings to connect water to cooler For
indoor kit use copper tubing and #62522 self pierc­
ing saddle valve.
PUT IN OVERFLOW PIPE (Fig. 11)
1 Push the drain fitting through the washer and
water tray hole Tighten the ring nut. Screw the
overflow pipe into the drain fitting Repeat for
the second tray.
N O T E ; I N S T A L L D R A I N F I T T I N G
INVERTED iF COOLER IS MOUNTED ON A
PAD.
CUT OFF THE OVERFLOW PIPETOP
FLUSH WITH THE HEXAGONAL RING.
2 Put in the float valve side tray first The cros­
sover tube and grommet MUST be on the float
valve side (Fig 12)
3 Push the crossover tube into the grommet. Use
soap or detergent as a lubricant . DO NOT USE
OIL
COtHPRESSION
NUT ______ ____
' ........ N
JÉP \ I
COMPRESSION
NUT
FSHRULE
OUTDOOR
FAUCET
OUTDOOR
FAUCET
ADAPTER
COLD S addle
WATER VALVE
PIPE
£IGUREi10.i
4 Put the second water tray in place. Push the
crossover tube into the grommet.
ADJUST WATER LEVEL
5. Turn on the water. Check the water level when
the valve shuts off. If the water level is above the
tray water level mark bend the float rod down If
the level is too low, bend the rod up.
NOTE: CHECK THE CROSSOVER PIPE
GROMMETS AND ALL CONNECTIONS
FOR LEAKS.
еяоммет
PUT LOUVEPS ON COOLER
See page 11