Vleaning exterior and attachments, Caution, Cleaning exterior and attachments – Sears Vacuum Cleaner User Manual
Page 14
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE BELT:
Loop the new belt on the motor drive shaft.
(NOTE:
See page 3 for Belt #.)
Loop the other end of the belt on the belt groove on
the brush assembly.
Align the square
extension on each
end cap with the
slots in the frame of
the base.
Press firmly, checking to see that each end is com
pletely inserted.
Check to see that the belt is centered in the belt
groove and that the brush assembly turns freely.
Reinstall the lower plate by placing the front tabs on
the plate into the slots on the nozzle housing and
pushing the plate to the rear until the back clips snap
into place. Pull the tabs to the outside.
Return the cleaner to the upright position before
plugging into the electrical outlet.
VLEANING EXTERIOR AND ATTACHMENTS
1.
Unplug cord from wall outlet.
DO NOT drip water
on cleaner.
, Clean exterior using a clean, soft cloth that has
been dipped in a solution of mild liquid detergent
and water, then wrung dry. Wipe dry after
cleaning.
, To reduce static electricity and dust build-up, wipe
outer surface of cleaner and attachments.
4. Wash attachments in warm soapy water, rinse and
air dry.
Do not clean in dishwasher.
DO NOT USE AHACHMENTS IF THEY ARE WET.
A
CAUTION
Attachments used /n dirty areas (under a
refrigerator) shoutd not toe used on other surfaces
unfit they are wcKhed. They coutd leave marks.
13