Sears Vacuum Cleaner - Manual (Page 6)

Using a screwdriver, tighten the screw.
A
CAUTÊON
DO NOT overtighten. Overtightening couid strip the
screw hotes.
DO NOT operate the cieaner without the screw in
piace. -N*
CORD ASSEMBLY
Make sure the quick release upper cord hook is in
the upright position,
Lower-
Cord Hook
Remove the
wire tie from
the power
cord. Wrap
the power _
cord arouhd
the upper
and lower
cord hooks.
J^UACHMENT
ASSEMBLY
TO ASSEMBLE
ATTACHMENTS
After the handle has been assembled to
thè body and the power cord has been
wrapped around the cord hooks, the
attachments can be assembled.
1. The wand can be attached to the
hose by inserting the small end of the
wand into the open end of the hose.
Be sure to align the tabs on the wand with
the "J" slots in the hose. Once the wand is
inserted into the hose it should be twisted to
the right to lock the tabs into the ”J" slots.
2. The wand and hose can then be routed in front
of the handle and over the hose support.
3. The wand can then be placed over the end of
the short hose, twisting as you push down.
4. The dusting brush can be placed in the holder in
front of the wand with the brush portion up.
5. The crevice tool can be slipped down into the holder
beside the wand.