Sears KENMORE 45520 - Manual (Page 16)

REMOVABLE OVEN DOOR
To remove:
1 . Open the door to the stop position (see iiiustratlon).
2. Grasp the door at each side and iift up and off the
hinges. Do not iift door by the handle. Glass break­
age or damage to the door could result.
NOTE: When the door is removed and hinge arms
are at stop positiont do not bump or try to move
the hinge arms. The hinges could snap back
causing an injury to the hands or damage to the
porcelain on the front of the range. Cover the
hinges with toweling or empty towel rolls while
working in the oven area.
To replace:
1. Hold the door over the hinges with the slots at the
bottom edge of the door lined up with the hinges.
The
hinge arms must still be in the stop
position.
2. Slide the door down onto the hinges as far as it will
go and close the door.
STOP (BROIL) POSITION
STOP POSITK»!
REMOVABLE OVEN RACKS
Be careful not to scratch the oven finish when Installing
or removing oven racks.
To install:
1. Set the raised back edge of the rack on a pair of rack
guides.
2. Push the rack in until you reach the bump in the rack
guide, then lift the front of the rack a bit and push the
rack all the way In.
To remove:
1. Pull the oven rack out, then up, in one motion. See
the cleaning chart.
Note: For best performance remove oven racks
during a clean cycle. If oven racks are left
in the range during a clean cycle, they will
darken, lose their luster and become hard
to slide. If you choose to leave the racks
in the oven, you can polish the edges of
the
racks with steel wool and apply a
small amount of vegetable oil to the rack
edges after the self-clean cycle. This will
make the racks easier to slide.
Note: The racks are designed with stop locks.
When the racks are placed correctly on
the rack support and extended from the
oven the stop locks prevent the racks
from tilting when removing foods from
them or placing foods on them.
15
NEMNT71-1