One-piece door without track, One-piece door with track, 0^l£■^p!ece^doòr1nstáhatîg – Sears 139.53535SRT1 User Manual

Page 5

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

:0^l£■^P!ECE^DoÒr1nstáHatîG^^

Before you begin, survey your garage area to

see whether any of the conditions below apply
to your installation.

Slack in chain tension

is normai when

garage door is closed.

One-Piece Door without Track

FINISHED CEILING

Support bracket

&

fastening

hardware is required.

See page 17.

Safety

Reversing

"Gap between floor and bottom Sensor

Safety of door must not exceed 1/4".

Reversing Sensor

Based on your particular requirements, there are

several installation steps which might call for
materials and/or hardware not included in the carton.

• Step 1, page 13 - Look at the wall or ceiling above

the garage door. The header bracket

must

be

securely fastened to structural supports.

• Step 5, page 17 - Do you have a finished ceiling in

your garage? if so, a support bracket and
additional fastening hardware (not supplied) may
be required.

• Safety reversing sensor, page 21 - Depending on

garage construction, wood blocks may need to be
securely fastened to mounting locations before
sensors are installed.

• Step 10, page 22 - Alternate floor mounting of the

safety reversing sensor will require hardware that
is not provided.

• Step 11, page 25 - Generally, a one-piece door

does not require reinforcement. If your door is
lightweight, you can refer to the information
relating to sectional doors on page 24.

• Step 11, page 25 - Depending on your door's

construction, you might need additional mounting
hardware for the door bracket.

• Do you have an access door in addition to the

garage door? If not, Model 53702 Emergency Key

Release is required. See page 38.

• The gap between the bottom of the garage

door and the floor cannot exceed 1/4".
Otherwise, the safety reverse system may not

work properly. See page 30. The floor or the door

should be repaired.

One-Piece Door with Track

Floor must be level

Safety across width of door

Reversing

Sensor

Safety

Reversing

Sensor

Closed Position

Cable

Cable Trolley

Chain

Header Curved

Bracket Door Arm

—y

..... O O 0 000 0,00 00)

'

'Door Straight

Bracket Door

Arm

T-rail

Emergency Release

Rope & Handle

You may find it helpful to refer back to this page
as you proceed with the installation of your
opener.

Advertising