Sears 536.884811 - Manual (Page 19)

SERVICE AND ADJUSTMENTS
TO REPLACE BELTS
The drive belts on this snow thrower are of special con-
stnjction and should be replaced with original equipment
bells available from your nearest SEARS Store or Serv­
ice Center,
You will need the assistance of a second person while
replacing the belts.
Drain the gasoline from the fuel tank by removing the fuel
line. Drain the gas and reinstall fuel line.
CAUTION: DRAIN THE GASOLINE OUT
DOORS, AWAY FROM FIRE OR FLAME.
AUGER DRIVE BELT
If your snow thrower will not discharge snow, and the
auger drive belt is damaged, replace it as follows:
® Disconnect the spark plug wire,
® Remove the belt cover {See Fig. 26)
• Loosen the belt guides (See Fig. 28) and pull
away from the drive pulley.
® Loosen the auger idler pulley (See Fig. 28) and
slip the belt out
® Engage the auger drive lever. This will puli the
brake assembly (See Fig 27) away from the
pulley and allow the belt to be slipped out
® Remove the belt from the auger drive engine
pulley.
® Install the original equipment replacement belt In
reverse order of removal,
® Release the auger drive lever.
® Place the drive belt onto the auger drive pulley.
• Adjust the drive belt (see To ’Adjust Auger Drive
Belt paragraph on page 18).
® Adjust the belt guides (see To Adjust The Bell
Guides paragraph on page 20),
® Reinstall the belt cover.
® Check clutch control cable adjustment (see page
18).
® Reconnect the spark plug wire.
TRACTION DRIVE BELT
IMPELLER
DRIVE
BELT
BELT GUIDE
{Right Hand)
AUGER IDLER
PULLEY
BRAKE ASSEMBLY
TRACK DRIVE
PULLEY
BELT GUIDE
(Left Hand)
» AUGER DRIVE
PULLEY
TRACK DRIVE
IDLER PULLEY
FIG. 27
19