To replace friction wheel, Service and adjustments – Sears 536.884811 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
TO REPLACE FRICTION WHEEL
lithe snowthrower will not move forward, and the friction
wheel is worn or damaged, you need to replace it, as
follows;
® Drain the gasoline from the fuel tank by removing
the fuel line. Drain the fuel and reinstall the fuel line
® Disconnect the spark plug wire.
® Stand the snow thrower up on the auger housing
end (See Fig. 32).
• Fiemove the bottom panel (See Fig. 29).
® Disconnect the right side track connecting rod..
® Rotate the right side track until It is parallel to the
ground (See Fig 33).
® Remove the three (3) fasteners securing thefriction
wheel to the hub (See Fig. 32).
SERVICE AND ADJUSTMENTS
A
CAUTION: DRAIN GASOLINE OUTDOORS
AWAY FROM FIRE OR FLAME.
® Move the shifter lever into first (1) gear
® Loosen the four No. 10 keps nuts securing the
bearing plate (See Fig. 33). Do not remove the nuts.
NOTE: Reassembly will be easier if you place a piece of
tape over each of the carriage boit heads on the inside of
the motor mount before you remove the nuts,
® Move the speed select lever into sixth (6) gear.
® Remove the four No, 10 keps nuts.
® Remove the bearing plate
®
Slide the hex shaft to the right until the friction wheel
can be removed.
® Install the new friction wheel loosely on the hex
shaft,
• Reinstall the removed parts in reverse order of re
moval.
21