Motor safety filter cleaning, Warning, Dark foam filter – Sears CO1ZARD10UOO-4370537 User Manual
Page 13: White electrostatic filter, Cleaning exterior and attachments, Caution
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MOTOR SAFETY FILTER CLEANING
There are two motor safety filters: 1. a dark foam filter Incorporated in the red frame and
2, a white electrostatic filter that is laid on the back side of the dark foam filter
These filters should be checked with each bag change. The dark foam filter can be washed,
per the instructions below and the white filter must be replaced when dirty.
WARNING
IC
a
'^%1 I
m
CII I
I IO
a p t
CSI
u
Do not operate the cleaner without
the motor safety filter Be sure the
filter is dry and properly installed to
prevent motor failure and/or
electrical shock.
1. Unplug cord
from wall outlet
and remove bag.
2. Pull out safety
filters as shown.
DARK FOAM FILTER
This filter and the frame can be washed in
warm soapy water, rinsed and air dried.
DO
NOT clean in a dishwasher or clothes
washer or install while damp.
WHITE ELECTROSTATIC FILTER
This filter must be replaced when dirty. It
should be replaced regularly depending on
use conditions
The filter CANNOT be
washed as it will lose its dust trapping
ability.
3. Pee! the white
filter off the dark
foam filter as
shown. Lay a new
white filter on the
dark filter by align
ing the notches in
the filter with the
legs of the frame.
White
Electrostatic
Filter
Dark Foam
Filter
The new filter can be purchased under
part number 4369971 at your focal Sears
Service Unit, 20-86885 at most Sears
Retail stores, or ordered by calling the
Toll Free Number 1-800-366-7278 for
English speaking operator or 1-800-659
7084 for Spanish speaking operator.
4.
Snap filter
back into canis
ter.
5. Insert bag.
CLEANING EXTERIOR AND ATTACHMENTS
Unplug cord from wall outlet
Do not drip
water on cleaner.
Clean exterior using a dean, soft cloth that
has been dipped in a solution of mild liquid
detergent and water, then wrung dry, Wipe
dry after cleaning.
To reduce static electricity and dust build
up, wipe outer surface of cleaner and
attachments.
Wash attachments in warm soapy water,
rinse and air dry.
Do not clean in dish
washer.
DO NOT USE ATTACHMENTS IF THEY ARE
WET
CAUTION
Attachments used in dirty areas,
such as under a refrigerator, should
not be used on other surfaces until
they are washed. They could leave
marks.
13