Sears CO1ZARD10UOO-4370537 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
5.
Carefully
insert and
twist
screwdriver
at each
brush
support to
free brush
from base.
Brush
Support
6. Remove worn
belt.,
7.
Slide brush
supports off to
check and clean
brush support
areas. See
BRUSH
ASSEMBLY for
picture of
complete brush
assembly.
TO REPLACE BELT:
1, Slide washers and brush supports onto
brush assembly.
2. Install
new belt
over motor
drive, then
over brush
sprocket.
NOTE:
See
PARTS AND
FEATURES
for Belt #
hfotor
Olive
Brush
Support
Brush Sprocket
3. Snap brush
supports into
place on base.
Be sure brush
supports are
not upside-
down.
4. Line up
front of cover
and base.
Rest cover
on front edge
of base as
shown.
Cover
B3s^
5.
Tilt cover to
back. Press
cover firmly until
On»*Slr*i
bKJo IdUo briap
into place.
Replace cover
screws, light
bulb and light
cover.
15