To set the clock, To set the timer, To display the clock while the timer is operating – Sears 61118 User Manual

Page 12: Conventional clock and timer, The clock, Timer, To change or cancel the timer setting, Clock and timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Clock and Timer

(on some models)

----

CLOCK

TtMER

aPiforF

f j l

n n

I I u u

(appearance may vary)

Follow the directions below if your range has the clock
and timer shown above. You have the choice of having
the timer show the time counting down or the time of
day In either case, the timer will signal at the end of
the timer period to alert you that the rime is up.

To Set the Clock

NOTE} When you first plug in the range or after a
power failure, the entire Clock/Timer display will

light up.

1. Press the CLOCK pad.

2. Press and hold the UP or DOWN pad and the time

of day will change 10 minutes at a time. To change
the time by single minutes, give the pads short taps.

3. Press the CLOCK pad to start the clock.

To Set the Timer

1. Press the TIMER ON/OFF pad,

2. Use the UP and DOWN pads to set the timer.

Short taps on the UP or DOWN pad change the
uraers setting one minute at a time. Pressing and

continuing to hold the UP pad increases the setting

ten minutes at a rime.

3. Once you have set your dmer, press the TIMER

ON/OFF pad to start timing. As the timer counts

down a signal will indicate when one minute is left.

After this signal, the display will count down in

seconds. When time runs out, a final signal wiD sound.
Press the TIMER ON/OFF pad to stop the signal-

To Display the Clock While

the Timer is Operating

Pressing the CLOCK pad while the timer is operating

will not interfere with the timers operation; the display
will change to show the clock, but the timer will conrinue
to count down and will still signal when time is up.
Press the TIMER ON/OFF pad again to change the
display bach to show the timer.

Conventional Clock and Timer

(on some models)

The clock and timer axe helpful devices that serve

several purposes.

The Clock

To set the clock,

push

in

the knob

and turn it to the right. Let the
knob out when the clock hands

reach the correct time, Condnue
turning the knob to OFF.

Timer

The timer has been combined with the range clock.
Use it to time all your precise cooking operadons.

You'U recognize the dmer as the pointer that is

different in color than the clock hands. Minutes are
marked up to 30, and hours are marked up to 4 on the
center ring of the dock.

To set the timer,

turn the knob to the left—without

pushing in~™-undl the pointer reaches the number of

minutes or hours you want to time.

At the end of the set time, a buzzer sounds to tell

you time is up.

Turn the knob—^without pushing

in—until the pointer reaches OFF and the buzzer stops.

To Change or Cancel the Timer Setting

When the dmer is counting down, use the UP and

DOWN pads to change the remaining time, or press

the TIMER ON/OFF pad to stop the dmer. The timer

cannot be cancelled unless you have fully completed
“set timer” instructions above.

12

Advertising
This manual is related to the following products: