Step 10, Installing the anti-tip device, Converting to lp gas – Sears 61118 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 10
B
i
If*
j I
A . r «Mmi«- Mk
»
Installing the Anti-Tip Device
• Range must be secured with an approved Anti
Tip device.
■ Unless properly installed, the range could be
dpped by you or a child standing, sitting or
leaning on an open door,
• After installing the Anti-Tip device, verify that it
is in place by carefully attempting to tilt the range
forward.
• This range has been designed to meet all recogni
2
ed
industry tip standards for all normal conditions,
• The use of this device does nor preclude ripping
of the range when not properly installed.
• If the Anti-Tip device supplied with the range
does nor fit this application, use the universal
Anti-Tip device WB02X7909.
1. Mark the wall where the RIGHT EDGE of the
range is to be located. Be sure to aMow for the
countertop overhang if you intend to install the
range next to cabinets.
Slotted ^
head Bfeaiassw
screw
f
Approx. 20“
Marked edge of range
2.
Locate the outside edge of the device (5,4 cm)
toward the center of the ranee from the marked
edg.ofie«nge.
^
3. Using the device as a template, mark the position of
the hole for the screw.
4. For wood construction, drill a pilot hole at an angle
of 20 degrees from the horizontal. A nail or awl may
be used if a drill is not available.
Mount the Anti-Tip device with the screw provided.
For cement or concrete construction, you will need a
1/4" X
VA'’
lag bolt and a 1/2" O.D. sleeve anchor,
which are not provided. Drill the recommended size
hole for the hardware.
Install the sleeve anchor into the drilled hole and then
install the lag bolt through the device. The bolts must
be properly tightened as recommended for the hardware.
5. Slide the range against the wall, and check for
proper installation by grasping the front edges of the
rear surface unit openings and carefiilly attempting
to tilt the range forward.
WHEN AT I HOOKUPS ARE COMPLETED:
MATCF SliRF AT T OP THF r*p|xjTROT S ARF
LEFT IN THE OFF POSITION.
MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UN OBSTRU CTED.
Converting to LP gas
(or converting back to natural gas from LF)
This range leaves the factory set for use with natural
gas. If you want to convert to I P gas, the conversion
must be performed by a qualified LP gas installer.
The conversion instructions, sticker and LP orifices
can be found attached to the range next to the pressure
regulator.
There is a second set of instructions included in the
envelope containing the product wiring diagrams on
the back of the range. Keep these instructions and the
orifices in case you want to convert back to natural gas.
39