Sears 113.20765 - Manual (Page 6)

Item
1
2
3
4
5
6
7
10
Description
Screw, Serrated Truss Hd
Leg ...... ............ .........
Stilfener, Side .............. .
•Lockwasher, Ext 1/4 ,
*Nut. Hex 1/4^20 .........
Stiffener, End ........ ....
*Nut, Hex 1/2-13 ..........
Foot, Leveling ...............
‘Washer 17/64 ID...........
Screw Hex Hd 1/4-20 x 1-
1/4-20 x 5/8 .
1/4
Olr
24
4
2
24
24
8
4
4
4
"Parts contained in Loose Parts Bag No 56037
assembly
SPECIAL NOTE; it is normal for this scroll saw to
vibrate during operation. For this reason the scroil
saw MUST be fastened down securely to a leg set or
workbench during operation.
This Leg Set is inciuded with Mode! No 113 207660
only.
NOTE: For illustrative purposes, the Scroll Saw is
shown mounted on the Craftsman Catalog No 9­
22239 Steel Leg Set
ASSEMBLING STEEL LEGS
T insert the Truss Head Screws through the holes
in the legs, then through the holes in the
stiffeners. MAKE SURE THE SCREWS GO
THROUGH THE HOLES IN THE SIDE
STIFFENERS MARKED “X"
2 install lockwashers and screw on the nuts, butdo
not tighten until completely assembled.
3. install leveling feet as shown. To level Leg Set,
loosen nut on inside of leg and turn nut on outside
to raise or lower feet. Adjust all four ievelers, if
necessary, and then tighten nuts on inside of leg
NOTE: These Ievelers are not intended for height
adjustment
SIDE STIFFNER
END
STIFFNER
SCREWS THROUGH
HOLES MARKED ‘X"
1/2 IN- HEX NUTS
LEVELING FOOT