Troubleshooting – Sears 580.768050 User Manual

Page 17

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

TROUBLESHOOTING

PROBLEM

CAUSE

CORRECTION

Pump has following problems:

failure to produce pressure, or

1. Nozzle in low pressure mode.

1. Twist chemical valve handle

to place in low pressure mode.

erratic pressure, chattering, loss of

2. Water inlet is blocked.

2. Clear inlet

pressure, low water volume.

3. Inadequate water supply

3. Provide adequate water flow at

least 3 gpm.

4. Iniet hose is kinked or leaking

4. Straighten inlet hose, patch leak.

5. Clogged water inlet screen.

5. Replace

t

clean water inlet

screen.

6. Water supply is over 140°F.

6. Provide cooler water supply.

7. Outlet hose is blocked.

7. Clear blocks in outiet hose.

8. Outlet hose leaks.

8. Replace outlet hose if leaking.

9. Gun leaks.

9. Replace O-ring or gun rf

necessary. .

10. Nozzle is r^tructed.

10. Clear nozzle. .

11. Pump is faulty.

11. Contact Sears Service

Department.

Detergent fails to mix.

1. Detergent line is collapsed or

looked

1. Repair or replace detergent

line. '.

2. Chemic^ tank filter is clogged.

2. Replace tank

3. Nozzle is in high pressure mode.

3. Twist chemical vsdve handle

to place in low pressure mode.

4. Dial-a-Cleaner knob is in off position.

4. Rotate knob for desired chemical.

Engine runs good when not spraying

but dies when you begin to spray.

Engine speed is too slow.

Contact Sears Service Department.

Engine will not start; or starts

1. Dirty air cleaner

1. Clean or replace air cleaner.

and runs rough

2. Out of gasoline.

2. Fill fuel tank.

3. Stale gasoline.

3. Drain gas tank; fill with fresh fuel.

4. Spark plug wire not connected

to spark plug.

4. Connect virire to spark plug.

5. Bad spark plug.

5. Replace spark plug.

6. Water in gasoline.

6. Drain gas tank; fill with fresh fuel.

7. Overchoking or flooded

7. Set engine throttle cwitrol lever to

fast position, choke in run

position.

8. Excessively rich fuel mixture.

8. Contact Sears Senrice

Department.

9. Intake valve stuck open or closed.

9. Contact Sears Service

Department.

10. Engine has lost compression.

10. Contact Sears Service

Department.

Engine shuts down during

1. Out of gasoline.

1. Fill fuel tank.

operation

2. Air filter dirty

2. Replace Air filter.

Engine lacks power.

Dirty air filter.

Replace air fitter.

17

Advertising