Sears 580.768050 User Manual

Page 3

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

The high pressure equipment is designed to be

used with Sears authonzed parts only. If you use

this equipment with parts that do not comply with

minimum specifications, the user assumes all risks
and liabilities.

Some chemicals or detergents may be harmful if

inhaled or ingested, causing severe nausea,

fainting or poisoning. The harmful elements may
cause property damage or severe injury.

Do not allow CHILDREN to operate the cleaning

system at any time.

Operate engine only at governed speed. Running
the engine at excessive speeds increases the

hazard of personal injury. Do not tamper with parts

which may increase or decrease the governed

speed.

Do not wear loose clothing, jewelry or anything

that may be caught in the starter or other rotating

parts.

Before starting the cleaning system in cold
weather, che<^ all parts of the equipment and be
sure ice has not formed there.

Units virith broken or missing parts, or without

protective housing or covers should NEVER be
operated.

The muffler and air cleaner must be installed and

in good condition before operating the cleaning

system. These components act as spark arrestors

if the engine backfires.

.

Check the fuel system for leaks or signs of
deterioration such as chafed or spongy hose,

loose or missing clamps or damaged tank or cap.

Correct all defects before operating the cleaning
system.

Do not spray flammable liquids.

Never allow any part of the body to come in

contact with the fluid stream. DO NOT come in

contact with a fluid stream created by a leak in the
high pressure hose.

High pressure streams of fluid this equipment
pr^uces can pierce skin and its underlying

tissues, leading to serious injury and possible

amputation.

Never aim the gun at people, animals or plants.

High pressure spray can cause paint chips or
other particles to become airborne and fly at high
speeds.

Always wear eye protection when you use this
equipment or when you are in the vicinity where
the equipment is in use.

Operate the pressure at no more than the PSI fluid

pressure rated for your cleaning system.

Never move the machine by pulling on the high
pressure hose. Use the handle provided on the

top of the unit.

Always be certain the spray gun, nozzles and
accessories are correctly attached.

Never use a spray gun which does not have a

trigger lock or trigger guard in place and in
working order.

Use a respirator or mask whenever there is a

chance that vapors may be inhaled. Read all

instructions with the mask so you are certain the
mask will provide the necessary protection against
inhaling harmful vapors.

High pressure spray may damage fragile items
including glass. Do not point spray gun at glass

when in the jet spray mode.

Keep the hose connected to machine or the spray
gun while the system is pressurized.

Disconnecting the hose while the unit is.
pressurized is dangerous.

Hold the spray gun firmly in your hand before you
start the unit. Failure to do so could result in an
injury from a whipping spray gun. Do not leave the
spray gun unattended while the machine is i
running.

The cleaning area should have adequate slopes

and drainage to reduce the possibility of a fall due
to slippery surfaces.

Keep water spray away from electric wiring or fatal
electric shoclj^may result.

Do not secure trigger gun in the pull-back (open)
position.

Do not by-pass any safety device on this machine.

The muffler and engine heat up during operation
and remain hot immediately after shutting it dowti.
Avoid contact with a hot muffler or engine or you
could be severely burned.

Operate and store this unit on a stable surface.

Always store cleaning system with the

Diat-a-Cleaner™ knob in the OFF position.

High pressure hose can develop leaks from wear,
kinking, abuse, etc. Water spraying from a leak is

capable of injecting material into skin. Inspect

hose each time before using it. Check all hoses for

cuts, leaks, abrasions or bulging of cover, or
damage or movement of couplings. If any of these
conditions exist, replace hose immediately. Never

repair high pressure hose. Replace it with another

hose that meets minimum pressure rating of your
cleaning system.

LOOK FOR THIS SYMBOL TO POINT OUT IMPORTANT SAFETY PRECAUTIONS. IT

MEANS “ATTENTIONMl BECOME ALERT!!! YOUR SAFETY IS INVOLVED.”

Advertising