Sears Refrigerator - Manual (Page 14)

Reversing Door Swing
(continued)
Reversing hardware on cabinet
step 1—Transferring botfom hinge bracket to
the left side (continued).
(d) Reinstall the trim
plate on the bottom right
side of the cabinet, using
the Torx screws removed
in step (a) above.
Transferring the center hinge bracket
(a) Remove the hinge bracket (and shim glued to it)
from the center right side of the cabinet by removing
the three outermost Torx screws.
(fa) Remove the three outermost Torx screws from the
center (eft side of the cabinet and screw them into the
holes at the right side uncovered in Step (a) above.
(c) Place the center hinge bracket over the holes at
the center left side of the cabinet, insert the screv^s
you removed from the opposite side, and tighten them.
Transferring the top hinge
Interchange hinge and screws at top right with
screws at top left of the cabinet. Do not tighten
the screws on the binge side at this time.
Transferring doorstops
(a) Remove metal doorstop on bottom right of
each door,
(fa) Replace door stops on left side after handles
have been moved.
Transferring door handles
Freezer door
(a) Remove screw holding handle to top of door.
(fa) Remove two screws holding handle to bottom of
door. (Some models have o third screw. Remove it, too.)
(c) Transfer screw from handle hole in top right of
door to opposite side.
(d) Transfer plug button in top left of door to
opposite side,
(e) In reverse order, reassemble handle to right side
of door using screws removed in Steps (a) and (b).
14