Sears 625.34823 - Manual (Page 11)

SECTION 3 STEP BY STEP GUIDES TO INSTALL
7.
CONNECT THE FILTER
{Refer to your plan drawing on page 7, and to page
8
.)
- SOLDER COPPER OR CPVC PIPE
Read the important note in step 6. Then put the
3. gaskets, tubes and nuts shown in FIG. 9, or the
flexible connectors* (Sears kit, page 8) onto the
inlet-outlet adaptors or bypass valve.
NOTE: The nuts, tubes and gaskets are for 3/4 in.
plumbing connection. For 1 in. connection, do not
use the nuts, tubes and gaskets. From your local
hardware store, buy 2 sweat adaptors (1 in. female
thread x 1 in. sweat) and plumb directly to the in­
stallation adaptors or bypass valve. Threads on the
installation adaptors and bypass valve are 1 in. pipe
thread.
Measure, cut and put all pipe and fittings
D> together up to the main water pipe, or to the
bypass valve(s) you installed in step 6.
When all piping fits together good, solder (or
C. solvent cement CPVC) all joints following tips
on page 20.
FIG. 9 INLET-OUTLET FITTINGS
Gasket
inlet and Outlet
Adaptors
Tube Nul
/ Nu(
Tube
Gasket
Bypass
Valve '
INLET
▲ CAUTION: BEFORE SOLDERING, DISCONNECT
NUTS (FIG. 9) AT THE ADAPTORS OR BYPASS
VALVE. THIS WILL STOP THE HEAT, CAUSED
BY THE SOLDERING, FROM GOING INTO THE
FILTER VALVE AND MELTING PLASTIC PARTS.
After plumbing cools, put nuts back on and tighten.
THREADED PIPE
Read the important note in step 6. Then
3. measure, cut, th read and put together pipe and
fittings from the inlet-outlet adaptors (or bypass
valve) up to the main water pipe, or to the
bypass valves installed in step 6.
NOTE: For 1” connection, use a 1” fitting directly
on the installation adaptors or bypass valve. Threads
on the adaptors or bypass valve are 1 in. male pipe.
b Include union fittings or flexible connectors*
■ (Sears kit, page 8).
Cut pipe lengths exact for correct aligning, and to
C. prevent stress on the filter valve. Use pipe dope
or teflon tape on all outside threads.
CAUTION: BE VERY CAREFUL WHEN PUTTING
PIPE FITTINGS ONTO THE PLASTIC THREADS
OF THE INLET-OUTLET ADAPTORS, OR THE
BYPASS VALVE. DO NOT CROSS-THREAD. DO
NOT OVERTIGHTEN.
‘Flexible connectors are not allowed in all areas. Check your local plumbing codes.
8. Fasten or support all piping (use pipe hangers)
to keep the weight of the plumbing off of the
filter inlet and outlet fittings, so they do not leak
or break.
11