Sears 625.34823 - Manual (Page 16)

SECTION 4 WATER FILTER TIMER/RECHARGE SETUP
4. Press button il] for every day of the week, each
time using button S to display ON (for recharge)
or OFF (no recharge) as needed.
5. After setting ON or OFF for Saturday, press but­
ton Ul to return the present time in the display.
D.
SET TIME OF RECHARGE (BACKWASH)
The fitter is factory set to begin recharge at 2:00 AM,
ending at about 2:40 AM. If a different recharge time
is desired, or needed (see note under step C, page
15) do the following.
1. Press the RECHARGE TIME button ¡g] once, to
display a flashing 2:00 AM, the factory setting.
2. Press the SET/CLEAR button [T] until the desired
recharge starting time shows in the display.
NOTE: Press button B and quickly release to move
the display ahead 1 hour at a time. Or, hold button
S to move the display ahead 2 hours each second.
3. Press button Q] to return the present time.
HOW OFTEN SHOULD YOU RECHARGE
(BACKWASH) THE FILTER?
The clarifier needs backwashing when you can see
sediments in the water, or when faucet water
pressure drops. When that happens depends on
how much sediment is in the water supply, and how
much water your household uses. You can use the
following table as a guide.
RECHARGE (BACKWASH) GUIDE
WATER CONOmON RECHARGES PER WEEK
normai sediments, dirt, etc. 1
nortnai sediments, dirt, etc.,
WrrH iron
2-3
high sediments, dirt, etc. 2
high sediments, dirt, etc.,
WITH iron
3-4
NOTE: The timer is factory programmed for Monday, Wednes­
day and Saturday recharge.
SECTION 5 TIMER FEATURES
VACATION
The day you leave on vacation or other long absence,
press (DO NOT HOLD) the VACATION ON/OFF
button H]. VAC begins to flash in the display. The
timer will keep time but the filter will not recharge
and waste water.
When you return, press the VACATION button [U
again to return the filter to service, and the correct
time of day in the display.
Remember to do this or
the filter will not recharge and you will soon have
sediments in your water supply.
NOTE: While in VACATION, the filter will go through a
recharge if the RECHARGE NOW feature (See be­
low) is used.
NOTE: To shut off the water supply to the filter, use
the plumbing bypass valve(s). . . FIG. 11, page 13.
RECHARGE NOW
For times you expect to use more water than usual,
use the RECHARGE NOW feature. Press the RE­
CHARGE NOW-HOLD button [E and hold in for 3
seconds. RCHG begins to flash in the display and a
recharge starts right away. You will have filtered
water when the recharge is over in about 35 minutes.
16.