Sears 113242502 - Manual (Page 14)

Ô Rip FENCE H EXACT-i-CUT
8
BLADE GUARD
7
MITER GAUGE
10 SAW&IADE
1 ON-OFF SWITCH
3
elevation lock handle
1 ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the blade
guard is correctly installed and operating properly.
The On-Off Switch has a locking feature. THIS FEATURE
(S INTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS LISE BY CHILDREN AND
OTHERS.
B. TO torn saw ON . , , stand to either side of the
blade never in line with it - . - insert finger under
switch lever and pull END of lever out
After turning switch ON, always allow the blade to
come up to full speed before cutting.
Do not cycle the motor switch on and off rapidly,
as this may cause the sawbiade to loosen. In the
event this should ever occur, allow the sawbiade to
come to a complete stop and retighten the arbor
nut normally, not excessively. Never leave the saw
while the power is "ON",
C. TO turn saw OFF .............. PUSH lever in. Never leave
the saw until the cutting toot has come to a
complete stop.
D. TO lock switch in OFF position hold switch IN
with one hand ,. , REMOVE key with other hand
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW
TABLE
SURFACE fIF BLADE IS TILTED,
RETURN IT TO VERTICAL (SO'^i POSITIONL
ALWAYS LOCK THE SWITCH "OFF". WHEN
SAW IS NOT IN USE ... REMOVE KEY AND
KEEP IT IN A SAFE PLACE ., - ALSO ... IN
THE EVENT OF A POWER FAILURE (ALL OF
YOUR LIGHTS GO OUT) TURN SWITCH OFF
. LOCK IT AND REMOVE THE KEY. THIS
WILL PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON.
14