Sears 113242502 - Manual (Page 7)

ASSEMBLY
ATTACHING LEGS
1,
2,
5.
6.
Turn the saw upside down
NOTE: DO NOT LAY IT ON THE FLOOR AS THIS
MAY SCRATCH THE TABLE SURFACE. PLACE IT
ON STRIPS OF WOOD OR PARTS OF THE PACKING
MATERIAL.
From among the loose parts, find the following
hardware:
16 Hex. Head Screws, 5/16—18 x 5/8 in. long
16 Hex. Nuts, 5/15—18 {approx, dia. of hole, 5/16 inj
16 Hex.. Head Screws, 1/4 in.—20 x 1/2 in. long
16 Hex, Nuts, 1 /4—20 (approx, dia. of hole, 1/4 in }
8 Hex.. Nuts, 1/2—13 (approx, dia of hole, 1/2 in.)
4 Leveling Feet
16 Lockwashirs, 1/4 in. External Type (approx, dia, of
hole, 1/4 in.)
16 Lockwashers, 5/16 in. External Type (approx, dia.
of hole, 5/16 in.)
NOTE: The four stiffeners are identical. BE SURE TO
ATTACH
THE SIDE STIFFENERS USING THE
OUTER HOLES ... ATTACH END STIFFENERS
USING INNER HOLES,
insert screws through legs then through stiffeners
Install lockwashers and nuts. DO NOT TIGHTEN.
After all screws, washers and nuts are installed, tighten
all nuts.
Install leveling feet.
Place saw in upright position.
BEFORE PROCEEDING WITH THE ASSEMBLY, THE
TABLE INSERT, BLADE SQUARENESS, AND BLADE
PARALLELISM MUST BE CHECKED AT THIS TIME.
CHECKING TABLE INSERT
1. Insert should be flush with table top. Check as shown.
Loosen flat head screw that holds insert end adjust the
four set screws as necessary. Tighten flat head screw,
Do not tighten screw to the point where it deflects the
insert--
2. To remove insert
A) Loosen Screw
B) Lift insert from front end, and pull toward front of
saw.
3. To replace insert.
Placé insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over screw. Tighten screw.
Do not tighten screw to the point where it will deflect
the insert.