Geaning parisof your cooktop, Control knobs, Control panel – Sears 629.42869 User Manual

Page 14: Porcelainized steel cooktop, Before you coll for service

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Geaning Parisof Your Cooktop

Control Knobs

The knobs on the control panel can be removed with

the controls in the OFF position. Pull each knob

straight from the shaft. Wash knobs in warm soapy

water or dishwasher; do not use abrasive cleansers or

materials. To replace each knob, match flat part of

knob opening with the spring on the shaft,

returning

in the OFF position.

Control Panel

Use mild cleansers, such as soapy water, glass cleaners

or mild liquid sprays, such as 409. Wipe with sponge,

damp cloth or paper towel.

Do not scrub with S.O.S

pads or Scotch Brite pads or abrasive cleansers.

Porcelainized Steel Cooktop

Wash cool cooktop with warm soapy water and

rinse. Polish with a diy cloth.

Do not use abrasive or caustic cleaning agents

which may permanently damage the finish.

NEVER WIPE OFF A WARM OR HOT

PORCELAIN

ENAMEL

SURFACE

WITH

A

DAMP CLOTH.

NOTE: The porcelain enamel used on your cooktop

is acid resistant, not acid proof. Therefore, acid foods

(such as vinegar, tomato, milk, etc.) spilled on the

cooktop should be wiped up immediately with a dry

cloth.

Before You Coll For Service

Check the following list to be sure a service call is really necessary. A quick reference of this manual may prevent

an unneeded service call.

If you do have a problem you cannot fix yourself, call your nearest Sears Store or Service Center for help. When

calling, have this manual handy with the model number. You will also need the serial number found on the serial plate

on the side of the vent chamber and the purchase date.

If nothing on the cooktop operates:

• check for a blown circuit fuse or a tripped main

circuit breaker.

• check if cooktop is properly connected to electric

circuit in house.

If griU heating element or cooktop does not get

hot enough:

• check if heating element is plugged in solidly.

• surface controls may not be set properly.

• voltage to house may be low.

If ventilation system is not capturing smoke

efficiently:

• check on cross ventilation in room or make up air.

excessiveamountofsmokeisbeing

created;

check

instructions for grilling, trimming meats. (See p.

11

.)

• outside wall cap may be trapped shut.

• cooktop may be improperly installed; check ducting

information. (See p. 5.)

• air filter may be improperly installed. (See p. 4.)

NOTE: If either element of the cooktop cartridge fails

to heat - switch the cartridge to the other side of the

cooktop. If it operates on that side, then the cooktop

control switch may be at fault. If it does not heat on

either side - indications are that the cartridge requires

service. In this event, you may speed service by

delivering the lightweight cartridge to an authorized

Sears Center.

All specifications subject to change by manufacturer without notice.

14

Advertising
This manual is related to the following products: