Lincoln LN-7 - Manual (Page 12)

Assembly and Installation The Lincoln Electric Company
Cleveland, Ohio 44117
SEC. J2.5 OPTIONAL FEATURES INSTALLATION
Sec. J2.5.3
K-178 Mounting Platform — LN-7 on Idealarc R3S
This is a turntable type platform for mounting the LN-7
on the top of Idealarc R3S power sources. Bolt the plat­
form to the lift bail per instructions supplied with the
platform.
September 1971
Sec. J2.5.5
Auxiliary Equipment Contacts
The Power for 115 volt AC auxiliary equipment can be
obtained from the terminal strip inside the control box.
The contacts are “hot” only when the gun trigger is oper­
ated. The current draw of this circuit must not exceed 1/4
ampere.
Route the leads thru the hole in the bottom of the con­
trol box to the terminal strip. Spare quick connect ter­
minals are provided on the terminal strip. Remove these
terminals and crimp them to the lead wires. Connect the
leads to numbers 32A and 7 on the terminal strip. Install a
suitable cable clamp on the leads to prevent excess tension
on the terminals and protect the lead insulation at the edge
of the hole.
March 1973
Sec. J2.5.7
K-162 Spindle For Mounting 10 thru 30 Pound
Spools
To mount the spindle kit for 10 thru 30 pound spools,
remove the shaft for the standard 50-60 pound wire coils
from the mounting framework. Install the spindle per the
instructions shipped with the kit.
Adjust the brake tension screw (see Sec. J3.1.6) on the
spindle as needed.
September 1971
Sec. J2.5.8
K-163 Undercarriage
The undercarriage includes the wheels, handle and hard­
ware. Mount the casters at the front and the wheels to the
rear of the platform. Be sure the round, rear axle is to the
rear of the mounting bolts that hold the U-shaped axle
member to the frame. Bolt the handle to the front of the
platform so the LN-7 can be tilted back and wheeled like a
two-wheel truck. Holes for installing the wire reel support
are provided in the platform.
September 1971
12-