Lincoln LN-7 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Assembly and Installation
The Lincoln Electric Company
Cleveland, Ohio 44117
Sec. J2.2.3 Continued
Gun Cable: LN-7 to Gun
Lay the cable out straight. Insert the connector on the
welding conductor cable into the brass block on the front
of the LN-7. Make sure it is all the way in and tighten the
locking screw with a 3/16” Allen Wrench. Keep this con
nection clean and bright. Insert the control cable polarized
plug into the receptacle below the nameplate.
Linconditioner'i’M Guns
^
For locations where smoke accumulation is a problem
and conventional exhaust systems are ineffective, the
available smoke removal type Innershield guns and vacuum
units can be used. Instructions are shipped with the
equipment.
April 1974
-8-