Tascam DA-P1 - Manual (Page 12)

Autolocating to the
record-in or out points
As stated earlier in the section on recording, the points on the tape where the deck
went into, and out of record mode most recently has been stored in memory
automatically.
To autolocate to the record-in point, hold down STOP and press REW when the
transport is in Stop and the time counter is in its ABS mode. " in" will show in the
left of the LCD display and the time counter will read out the time address the tape is
being located to. Actually, the tape is located to the point plus a 2-second preroll time.
To autolocate to the record-out point, hold STOP and press F FWD when the transport
is in Stop and the time counter is in its ABS mode. " at " will show in the left of the
LCD display and the time counter will show the time address the tape is being located
to. Actually, the tape is located to the point plus a 2-second preroll time.
O’ As with the user marked autolocation point, if there is no record-in or out marks in
memory, the time counter shows a broken line.
Choosing Selections
© ®
To advance to the next selection, press the forward SKIP button. The tape will fast-
forward to the next Start ID mark and stop. If PLAY is pressed before or after SKIP, the
tape automatically plays from that point on. You may press the forward or reverse
SKIP button a number of times to skip over several selections.
If you want the deck to go into pause at the end of skip functions, press PAUSE before
or after SKIP.
Editing Start and Skip iD Marks
Recording Start/Skip ID
Marks
IMPORTANT
o When Start IDs are added or erased, program numbers on tape get out of
order. Be sure to restore program numbers to proper sequence by going
through the RENUMBER operation (discussed below).
o No Skip ID can be recorded where a Start ID mark exists.
You can enter Start and Skip ID marks only when the tape is playing.
1. Press the ID SELECT switch until "WRT START” or "WRT SKIP” lights in the
LCD display.
2. Play the tape to locate to the point where you want to enter a Start or Skip ID mark,
and press RECORD.
12