Tascam DA-P1 - Manual (Page 13)

Erasing Start/Skip ID
Marks
Renumbering
\ I /
-~RENUM-<~ N
"WRT START" or "WRT SKIP" will flash to indicate that the corresponding mark
is being recorded. The Start ID mark is recorded for 9 seconds, and the Skip ID
mark is recorded for 1 second. Entering a Start ID requires that the current location
is more than 9 seconds (in terms of ABS time) apart from the previous Start ID
mark (if available).
O’ While a Start or Skip ID mark is being recorded, all the transport controls are
disabled except for STOP.
You can erase Start or Skip ID marks when the transport is in STOP, PLAY or PLAY
PAUSE.
o Erasing Start or Skip ID marks does not affect any audio data recorded on tape.
1. Press the ID SELECT switch until 'ERASE START " or "ERASE SKIP" lights in
the LCD display.
2. Press RECORD. The tape will rewind back to the beginning of the previous Start or
Skip ID mark, and will automatically start running at normal play speed (program
material muted) to erase the mark encountered, as confirmed by "ERASE START"
or "ERASE SKIP" flashing.
When erasing is complete, program material is unmuted. The tape continues to run
at normal play speed.
When adding or erasing Start ID marks, the program numbers on tape get out of order.
All programs then need to be "renumbered" in order, as follows :
1. When the transport is in PLAY, PLAY PAUSE or STOP, press the ID SELECT
switch until "RENUM" lights in the LCD display.
2 Press RECORD.
The tape will rewind to its beginning, and the renumbering process will start, as
confirmed by the RENUM indicator flashing.
13