SINGER 2001 TouchTronic - Manual (Page 32)

Replacing a Wound Bobbin
Raise needle and take-up lever to highest
position by turning hand wheel toward you.
A. Open slide plate; move bobbin latch to
left. Remove used bobbin.
B. Draw about 1 inch (2.5cm) of thread
from bobbin and insert bobbin in case.
Move bobbin latch slightly to the right
(sewing position). Pull thread into bob­
bin case Slot 1.
G. Draw thread under flat spring and around
to and past point 2, leaving 3 inches
(7cm) of free thread.
0. Close slide plate to prevent thread
from coming out of threading points
while raising the bobbin thread, as ex­
plained on next page.
26