SINGER 2001 TouchTronic - Manual (Page 91)

Although the Turkish hemstitch may be used creativeiy in appliqu^ work or in join­
ing patchwork, it is traditionaily used for hemstitching. A rich, tasteful appearance is
added to table and bed linens when hems are finished with Turkish hemstitching.
This type of hemstitching is best utiiized when used on firm, plainweave fabrics
such as linen or organdy.
TURKISH HEMSTITCH
Turkish Hemstitching
For effective drawn-thread work use the Turkish
hemstitch on fabrics from which threads can
readiiy be drawn, such as linen. Try using 2X
(two-times) with the Turkish hemstitch for a
loveiy exaggerated effect.
• Stitch: Turkish hemstitch |
• Stitch width: programmed or to suit application
or fabric
• Stitch length: programmed
• Stitch balance: programmed or to suit application
or fabric
• General purpose needle plate only
• Special purpose foot only
• Speed range: SLOW
• Insert a winged needle Style 2040 to create
large penetrations desirable in hemstitch­
ing. Use a fine cotton or siik thread.
• Foid a double hem of desired width on
iengthwise or crosswise thread of fabric.
Baste in place.
• Mark or baste a guideline on right side of
fabric just above top edge of hem.
• Piace work, right side up, under presser foot
with hem turned to the ieft.
• Lower presser foot and stitch, guiding hem
edge under needle so that stitches on right
side of hemstitching are made over hem
edge (in single thickness of fabric) and
stitches on left side penetrate thickness of
hem.
Turning a Corner
Hems in household linens are usualiy mitered at
the corners, but they may also be turned in with a
doubie overlap and stitched from edge to edge.
Mitered corners shouid be pivoted on needie at
inside point of the miter. To pivot, ieave needle in
fabric at corner.
Note: Slow speed setting is recommended for sewing with the Turkish Hemstitch
77