M mñ – Troy-Bilt 15009 User Manual
Page 42
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ONE OR TWO THREADS
PROTRUDING ABOVE
THE RECTANGULAR NUT
-RECTANGULAR
NUT
6. Push inward on the forward idler arm and re
move the clevis pin.
7. Note the two holes in the forward adjustable
link. Push inward on the forward idler arm and In
stall the clevis pin through the inside hole in the
forward adjustable link and back through the
hole in the idler arm. Secure the clevis pin with
the hairpin cotter.
I«
Photo 5-14: The correct distance to unscrew the
Forward Clutch Rod-one or two threads above the
rectangular nut.
3. Remove the belt cover.
4. Slip the forward drive belt off the engine-
driven pulley by pushing it off with your left hand
while pulling the engine starter rope with your
right hand (pulling on the starter rope makes the
pulley turn, aiding you in removing the belt).
m mñ
z ’ ^
%
Photo 5-15: Slipping the Forward Drive Belt off the
engine-driven pulley.
5. On the LEFT side of the tiller (as viewed from
the operator’s position) remove the hairpin cotter
from the clevis pin that connects the forward idler
arm to the forward adjustable link.
FORWARD
IDLER
ARM
IMPORTANT
While pushing inward on the forward idler arm,
make certain that the forward drive belt is
pushed off to the right-hand side of the tiller.
This creates more room to install the clevis pin
when you push the forward idler arm inward.
8. Place the forward drive belt In the grooves of
both the engine drive pulley and the transmis
sion pulley. Be sure the forward drive belt is to
the inside of the metal belt guide (on the right-
hand side of the tiller). Also-be sure the forward
drive belt is to the inside of the forward drive idler
pulley (on the left-hand side of the tiller).
'
WIRE FORM
BELT GUIDE
■
1
. .
FORWARD
DRIVE BELT
FORWARD DRIVE
IDLER PULLEY
Photo 5-16: Removing the Clevis Pin from the
Forward Idler Arm.
Photo 5-17: Overview of the belts and pulleys.
9. Readjust the forward drive belt tension by fol
lowing the instructions in “Handlebar Height
Adjustment’’ in Section 3.
10. Reinstall the belt cover and secure It in place
with the two nuts.
IMPORTANT
With the clevis pin installed in the inner hole in
the forward adjustable link, you will be limited
in the number of future belt tension adjust
ments you can make. When the time comes,
in future belt tension adjustments, that you
can not screw the Forward Clutch Rod any
farther into the rectangular nut in the Forward
Clutch bracket, you must replace the forward
drive belt. Before installing a new belt, be sure
to return the clevis pin to the outside hole in
the adjustable link.
40