Connect Tech Titan/cPCI - Manual (Page 14)

Titan/cPCI User’s Manual, Connect Tech Inc.
Revision 1.01 9
Installing the Titan/cPCI adapter in your system
Titan/cPCI and Rear I/O adapters
To install your Titan/cPCI or Rear I/O adapter in your computer follow these steps:
1. Turn off the power to your computer.
2. Remove the Titan from its packaging, and remove the protective rubber from the alignment
pins on the Titan’s front panel.
3. Insert your Titan/cPCI into an available front 3U slot or insert your Titan/cPCI Rear I/O
adapter into an available rear 3U slot. The black handle on the front panel should be on the
bottom, in the lowered position.
4. Push the Titan into the cPCI slot until the handle mates with the card cage. Lift the handle to
lock the Titan into place.
5. With a screwdriver, fasten the screw on the top of the panel into the card cage for added
mechanical security.
Your Titan/cPCI and Rear I/O adapters are very sensitive to static
electricity. Make sure you wear an anti-static wristband before you
remove the card from the anti-static shipping bag. When you remove
the board from the anti-static bag, handle it only by the edges and
place it on the anti-static bag or an anti-static mat.