MTD 243-723A - Manual (Page 5)

IRCUIT PROTECTION
^eep the load within the nameplate rating.
oo much load on a receptacle or accessory or an
pernal short circuit may cause circuit protector to
pen. If any circuit protector opens, disconnect all
lectrical loads and replace fuse or reset circuit breaker.
HUT-DOWN PROCEDURE
/hen shutting down your generator, use the following
rocedure:
. Remove all electrical load.
. Let engine run for a few minutes without load.
. Stop the engine.
. Do not leave generator until it has completely
stopped.
MAINTENANCE
Regular maintenance of your generator will lower
tperating costs and lengthen the life of the unit.
NFREQUENTSERVICE
f the unit is used infrequently, difficult starting may
esult. To eliminate hard starting, run generator at
east 30 minutes every week.
)UT OF SERVICE PROTECTION
f unit will be out of service for more than 60 days,
ollow instructions in the engine manufacturer's
jianual.
.NGINE MAINTENANCE
-or service and maintenance of the engine, follow the
nstructions in the engine manufacturer's manual.
BRUSHES
Once every year, inspect the generator brushes for
:hips and cracks. Replace brushes when they are worn
:o 1/4 inch.
Replace brushes in sets only, never singly.
To inspect brushes:
1. Remove cover plate (A). See Figure 4.
2. Loosen brush mounting screws (B).
3. Slide brushes (C) from holders.
4. Replace if worn to 1/4 inch.
5. Do not over tighten screws.
Replace only with brushes specified in parts list.
Other brushes may appear to be identical but may
have completely different mechanical and electrical
characteristics.
FIGURE 4
NOTE
This instruction manual covers various
models and all specifications shown
do not necessarily apply to your model.
Specifications
subject to change
without notice or obligation.